10-15-17, 03:38 PM
|
#3
|
A Pyroguard Emberseer
Join Date: Oct 2008
Posts: 1,246
|
A few follow-up notes: - When creating myFrame, do all things you would do normally, including SetSize or SetHeight/SetWidth, SetScale, and SetPoint, then pass myFrame to your pixel perfection function.
- Your pixel perfection function ought to be exactly that –– a separate function, which could be a local function.
- Said function will change myFrame's height and/or width. That is normal.
- During all stages where you want to either floor or ceil a measurement, be consistent. Stick to floor or ceil and do not alternate between the two unless absolutely necessary.
- The finished myFrame will have a different height or width or both than you originally created, which again, is normal.
|
|
|